When should industrial equipment be replaced instead of repaired?

Replace it if it is about 15 years old, the heat exchanger or compressor has failed, parts are obsolete, or the repair approaches half the cost of a new unit. Downtime on a production floor often costs more than the repair.

How much does industrial HVAC repair cost?

Industrial repairs cost more than a house call because of roof access, unit size, and parts. A belt, igniter, or capacitor is on the lower end. A heat exchanger, compressor, or control board costs more. A.R. Mechanical diagnoses first and quotes before major work.

Why are the overhead doors hard to open?

Hard-opening doors often mean the building is under negative pressure because exhaust fans have no make-up air. That also pulls cold air in wherever it can and can backdraft gas appliances. The fix is make-up air, not a stronger door closer.

Why is the shop freezing at one end and hot at the other?

Uneven bays are usually closed dampers, leaky or undersized ducts, a unit heater that is short of capacity, or a thermostat in the wrong place. High ceilings and open overhead doors make it worse. A.R. Mechanical checks airflow and equipment before quoting a replacement.

Do you install heat pumps on industrial buildings?

Yes, where the building and electrical service suit one. A cold-climate or hybrid heat pump can carry most of the North Bay heating season, with gas backup on the coldest days. A site visit confirms whether hybrid or gas-only is the better fit.

Can one rooftop unit be replaced without redoing the plant?

Often yes. A matched unit can use the existing curb and ducts if they are the right size and in sound condition. A bad curb, undersized ducts, or a unit that never heated the bay should be corrected at the same time.

Do you replace industrial HVAC equipment?

Yes. A.R. Mechanical replaces rooftop units, packaged units, boilers, and unit heaters, and corrects the duct or venting problems that should not be copied onto the new equipment. Sizing is based on the building load, not only the nameplate of the failed unit.

Can you handle a no-heat call in a shop or plant?

Yes. A.R. Mechanical prioritizes no-heat calls in the heating season. Office hours are Monday to Friday, 8:30 a.m. to 4:30 p.m. Call early, and have the unit make, model, fuel type, and any error code ready.

What is included in an industrial HVAC tune-up?

A tune-up covers filters, belts, burners or compressors, safety controls, flue or condensate drains, electrical connections, thermostats, and a visual check of ducts, curb, and intake hoods. Gas-fired equipment is checked by a licensed gas technician.

How often should industrial HVAC be serviced?

Inspect heating equipment before the heating season and cooling equipment in spring. Rooftop units in North Bay also need a check after winter for snow damage, blocked intakes, and pest nests. A dusty shop may need filter changes monthly.

FAQs - Page 6 of 23 - AR Mechanical

Categories: Industrial HVAC Service
When should industrial equipment be replaced instead of repaired?
read more
Categories: Industrial HVAC Service
How much does industrial HVAC repair cost?
read more
Categories: Industrial HVAC Service
Why are the overhead doors hard to open?
read more
Categories: Industrial HVAC Service
Why is the shop freezing at one end and hot at the other?
read more
Categories: Industrial HVAC Service
Do you install heat pumps on industrial buildings?
read more
Categories: Industrial HVAC Service
Can one rooftop unit be replaced without redoing the plant?
read more
Categories: Industrial HVAC Service
Do you replace industrial HVAC equipment?
read more
Categories: Industrial HVAC Service
Can you handle a no-heat call in a shop or plant?
read more
Categories: Industrial HVAC Service
What is included in an industrial HVAC tune-up?
read more
Categories: Industrial HVAC Service
How often should industrial HVAC be serviced?
read more

FAQs